OIL AND GAS/PETROLEUM ENGINEERING PROJECT TOPICS AND MATERIALS

This research project material is available: DETERMINATION OF FLOWING BOTTOM-HOLE PRESSURE FROM WELL-HEAD DATA.

Production well optimization and modeling is very important in the efficient management of oil and gas production from a well. A major factor contributing to this process is the accurate estimations of the flowing bottom-hole pressure at the formation as it helps in various petroleum production engineering analysis. Some of these analysis include studies on Vertical Lift Performance (VLP) and Inflow Performance. The effective determination of bottom-hole pressure has been a major concern in the industry due to several reasons as it can either be measured or estimated. In the case of measurement, a pressure gauge is needed down-hole, this is very accurate but expensive and time consuming. For this reason, this project will focus on flowing bottom-hole pressure estimation from wellhead pressure and data as it is generally cost effective and it can be easily determined within a short period of time.

Download Chapter One (DOC | DOCX)Download Chapter One (PDF)

Read full post »

This research project material is available: A STUDY OF THE NIGERIAN PETROLEUM RETAIL MARKET.

There has been a relative slow rate of growth in the Nigerian Petroleum sector for past decades with a far reaching influence of foreign presence. It is a well known fact that the Petroleum sector in any economy requires great amount of technology, capital with seasoned and experienced manpower for national development, however all of these are insufficient in the Oil and Gas Industry and Nigeria as a whole.

Download Chapter One (DOC | DOCX)Download Chapter One (PDF)

Read full post »

This research project material is available: AN ASSESSMENT OF GRAVEL PACKING METHODS USED IN THE PETROLEUM INDUSTRY.

The method to be adopted for this project is the use of sieve analysis and sucier correlation to determine the gravel pack size to be used for OBEN WELL 13 with formation sands gotten from the case study as mentioned above and useful information gotten from the internet, textbooks, petroleum journals. This method simply involves collecting core samples and running them through different sieves with different opening sizes, usually sieves with larger openings at the top and sieves of smaller opening at the bottom and plotting each weight retained on each sieve against the sieve opening size to determine the average formation sand size which is used to find accurate gravel size using sucier correlation.

Download Chapter One (DOC | DOCX)Download Chapter One (PDF)

Read full post »

This research project material is available: ANALYTICAL STUDY OF A SMALL SCALE BIOMASS GASIFIER.

The world is in a state of increasing energy demand accompanied by decreasing availability of conventional energy sources, the bulk of these energy sources being fossil fuel. The cost of fossil fuel, inclusive of cost of procurement, processing and utilization when considered alongside the deficient power generation from this energy source especially in developing countries is of exorbitant nature . Fossil fuel is in a state of decreasing availability. This unfavorable situation when considered with the detrimental effects of fossil fuel consumption on the environment poses a long overdue problem for confrontation.Need hitherto has arisen for the discovery and development of a cheap, alternative and environmental friendly source of energy such as biomass gasification.

Download Chapter One (DOC | DOCX)Download Chapter One (PDF)

Read full post »

This research project material is available: APPLICATION OF INTELLIGENT WELL COMPLETION IN OPTIMIZING PRODUCTION FROM OIL RIM RESERVOIRS.

An oil rim reservoir is a saturated reservoir with an oil column of limited thickness, less than 90 feet, overlain by a gas cap and underlain by an aquifer. Among the various challenges encountered in producing oil rim reservoirs, water and/or gas coning and breakthrough is the most prominent. Water and gas breakthrough occurs majorly due to heel-toe effect and reservoir permeability variations. Inflow control devices (ICDs) were deployed to mitigate the heel-toe effect thereby delaying the water and gas breakthrough.

Download Chapter One (DOC | DOCX)Download Chapter One (PDF)

Read full post »

This research project material is available: ASSESSING THE SPATIAL DISTRIBUTION AND LOCATIONAL IMPACT OF PETROL SERVICE STATIONS ON UVWIE LGA DELTA.

This project examines the locational impact of petrol stations in Uvwie local government area. Primary data was collected using questionnaire and secondary data was collected from Ikonos digital imagery of Warri metropolitan area, 50 petrol stations were analyzed and questions administered to the respondents regarding to the locational impact of the petrol stations in the study area. The study result reveals, that the establishment and location of these petrol stations in various parts of the study area is going on without due regard to planning criteria, safety and without considering the environment.

Download Chapter One (DOC | DOCX)Download Chapter One (PDF)

Read full post »

This research project material is available: ASSESSMENT OF SAFE AND COST EFFECTIVE METHODS TO MAXIMIZE PRODUCTION (PROFITABILITY) FROM A GAS-LIFTED FIELD.

This research work is basically carried out to optimize oil production from gaslifted wells via the installation of gaslift system. Data from XT field, a field in the Niger Delta will be used as a case study. PROSPER software will be used to design the well models. To fully optimize the XT field production system, sensitivity analysis will be performed to ascertain the effect of changing the tubing, water cut, surface choke, sub-surface safety valve sizing, skin and Gas-Oil Ratio (GOR) on the general well production system.

Download Chapter One (DOC | DOCX)Download Chapter One (PDF)

Read full post »

This research project material is available: COMPARATIVE STUDY BETWEEN OVERBALANCED AND UNDERBALANCED OIL DRILLING METHODS.

The technique used worldwide while drilling is known as overbalanced drilling. Which is defined as the drilling process where the hydrostatic pressure used exceeds the formation pressure. This is done with the main purpose of “killing” the well. However, there are numerous problems that accompany overbalanced drilling. Such problems are differential pipe sticking, loss of circulation, formation damage and other problems. A relatively new technique was introduced, known as underbalanced drilling, where the well is being drilled with a hydrostatic pressure less than that of the formation. Correct and proper execution of such technique eliminates problems associated with overbalanced drilling. More precisely, underbalanced drilling solves the issues of formation damage, differential pressure sticking and loss of circulation.

Download Chapter One (DOC | DOCX)Download Chapter One (PDF)

Read full post »

This research project material is available: DEREGULATION OF THE DOWNSTREAM OIL SECTOR IN NIGERIA AS A PANACEA TO ECONOMIC RECOVERY OF THE COUNTRY: (AN ANALYSIS OF 2010-2015 ECONOMIC PROGRAMME OF NIGERIA).

This study examined the deregulation of the downstream oil sector in Nigeria as a panacea to economic recovery of the country (An Analysis of 2010-2015 Economic Programme of Nigeria). In this study the researcher has find out some of the problems that are facing the deregulation of the downstream oil sector in Nigeria, these problems are continuous increase in petroleum price, scarcity of petroleum product . all these are the major problems that are facing the deregulation of the downstream oil sector which government have to help solving this problems by making fuel available and controlling the price.

Download Chapter One (DOC | DOCX)Download Chapter One (PDF)

Read full post »

This research project material is available: DESIGN AND CONSTRUCTION OF A MICROCONTROLLER BASED LIQUIFIED PETROLEUM GAS LEAKAGE DETECTOR USING GSM MODULE.

The aim of this project works is to Design and Construct a Microcontroller Based Liquefied Petroleum Gas leakage Detector system using GSM Module, a system capable of detecting if there is gas leakage and sends messages to specified number informing them about the leakage without any time delay.

Download Chapter One (DOC | DOCX)Download Chapter One (PDF)

Read full post »

This website have more than thousands of research topics and materials for each department. They are written in Microsoft Word format (This can easily be edited). Browse through the project topics, see free chapter one or table of content or abstract. You can ord...

Read full post »

The following sub-heads are always considered when writing chapter one in research work, all of them from the introduction of the project. They are: 1. Background of the study: this is a discussion that centers on the history of the area of the study to be...

Read full post »