THE DESIGN AND CONSTRUCTION OF A MICRO-CONTROLLER BASED LIQUID LEVEL DETECTING SYSTEM

Type: Project Materials | Format: Ms Word | Attribute: Documentation Only | Pages: 64 Pages | Chapters: 1-5 chapters | Price: ₦ 3,000.00

2,300 marked this research material reliable.
Call or whatsapp: +2347063298784 or email: info@allprojectmaterials.com
Excellent and professional research project topics and materials website. All the research tools, journals, seminars, essays, article, books, term papers, softwares and project materials for your research guide and final year projects are available here.

CHAPTER ONE
1.0 INTRODUCTION
The Water Level Controller System is an Electronic Equipment which when electrically connected to the starter of any given pump -set motor will control the operation of the pump- set depending upon the water level in the Source and Destination Storage Tanks. It Switches ON the Pump-set when Water level drops below pre-set level in Overhead Tank, Switches OFF the Pump-set when Water level in Overhead Tank becomes full ,Switches OFF the Pump-set when Water level is low in tank , and Switches ON the Pump-set when there is sufficient water in the tank.
Automatic water level controller circuit is an engineering project. It can automatically switch ON and OFF the domestic water pump set depending on the tank water level. You can implement this motor driver circuit at your home or college using less costly components. The main advantage of this water level controller circuit is that it automatically controls the water pump without any user interaction.
The automatic pump controller eliminates the need for any manual switching of pumps installed for the purpose of pumping water from a reservoir to an overhead tank. It automatically switches on the pump when the water level in the tank falls below a certain low level, provided the water level in the reservoir is above a certain level. Subsequently, as the water level in the tank rises to an upper level (M), the pump switched off automatically. The pump is turned on again only when the water level again falls below level in the tank, provided the level in the reservoir is above R. This automated action continues.
1.2 OBJECTIVE OF THE PROJECT
The objective of to design a microcontroller based water level controller device monitors and controls the level of water in the overhead or underground tank which composes of four indicating LEDs (red, orange, blue and yellow) for lower, medium , upper and full level. If it the level of water is full, the three LED goes OFF, then if it goes below high level, yellow is ON. Now, if it goes below medium level, blue would be turned ON, and it pumps automatically. This work was built using 89c52 microcontroller.
1.3 SIGNIFICANCE OF THE PROJECT


An Automatic Water Level Controller (AWLC) will automatically START the pump set as soon as the water level falls below the predetermined level (usually kept half or 2/3rd tank) and shall SWITCH OFF the pump set as soon as tank is full or water level in the lower tank is at below minimum level.
  1. This system provides you the flexibility to decide for yourself the water levels for operations of pump set in upper/lower tanks.
  1. Built in Indications for showing Full, Empty Levels in Upper Tank and Lower Tank Empty Indication.

c. Manual operation switch for special operations like watering the plants from pump set.

  1. The system ensures no overflows or dry running of pump there by saves electricity and water.
  1. Consume very little energy, ideal for continuous operation.
  1. Suitability: These water level controllers are ideally suited for normal water as well as for ultra low conductivity water with less than 1 micro/moh.
  2. Easy to Operate: this system come fitted with sensitivity setting which can be provided externally on a dial or with internal settings.
  3. Settings: It is equipped with technology which works on low or high sensitivity settings on the same machine and thereby saves costs of buying and using two different machines.
  4. Materials of Construction: this water control system is protected the against corrosion.
  5. Safety: This system is highly insulated, leakage proof and works without creating any noise.
  6. Save roofs
  7. Save water

1.4 APPLICATION OF THE PROJECT
Water level controller is an application which detects the level water then triggers the pump and blows alarm and vice versa. They are useful devices and play an important role in various industries such as automobile, irrigation, and also at homes, or wherever water is pump either underground or overhead.

1.5 SCOPE OF THE PROJECT
This water controller will give you a heads-up the instant over-head tank and underground tank is full or goes below the required level, hopefully giving you time to close windows and bring in possessions. The circuit draws virtually no current when the sensors are dry and the current consumption is low when the buzzer is activated. Alternately, a molded power supply with a simple voltage regulator to drop the voltage to 3 volts could be used. When the circuit is triggered, the buzzer is pulsed about once per second for a very short time.

1.6 LIMITATION OF THE PROJECT
Sensors used are built with conductive material, which means that they are subject to rusting or corrosion. When rusting occur the sensors will stop conducting thereby causing this device will stop working.

1.7 PROJECT WORK ORGANISATION
The various stages involved in the development of this project have been properly put into five chapters to enhance comprehensive and concise reading. In this project thesis, the project is organized sequentially as follows:
Chapter one of this work is on the introduction to Water level controller. In this chapter, the background, significance, objective limitation and problem of Water level controller were discussed.
Chapter two is on literature review of Water level controller. In this chapter, all the literature pertaining to this work was reviewed.
Chapter three is on design methodology. In this chapter all the method involved during the design and construction were discussed.
Chapter four is on testing analysis. All testing that result accurate functionality was analyzed.
Chapter five is on conclusion, recommendation and references.

THE DESIGN AND CONSTRUCTION OF A MICRO-CONTROLLER BASED LIQUID LEVEL DETECTING SYSTEM

Additional Information

  • The Project Material is available for download.
  • The Research material is delivered within 15-30 Minutes.
  • The Material is complete from Preliminary Pages to References.
  • Well Researched and Approved for supervision.
  • Click the download button below to get the complete project material.

Frequently Asked Questions

In-order to give you the best service available online, we have compiled frequently asked questions (FAQ) from our clients so as to answer them and make your visit much more interesting.

We are proudly Nigerians, and we are well aware of fraudulent activities that has been ongoing in the internet. To make it well known to our customers, we are geniune and duely registered with the Corporate Affairs Commission of the republic of Nigeria. Remember, Fraudulent sites can NEVER post bank accounts or contact address which contains personal information. Free chapter One is always given on the site to prove to you that we have the material. If you are unable to view the free chapter 1 send an email to info@allprojectmaterials.com with the subject head "FREE CHAPTER 1' plus the topic. You will get a free chapter 1 within an hour. You can also check out what our happy clients have to say.


Students are always advised to use our materials as guide. However, if you have a different case study, you may need to consult one of our professional writers to help you with that. Depending on similarity of the organization/industry you may modify if you wish.


We have professional writers in various disciplines. If you have a fresh topic, just click Hire a Writer or click here to fill the form and one of our writers will contact you shortly.


Yes it is a complete research project. We ensure that our client receives complete project materials which includes chapters 1-5, full references, questionnaires/secondary data, etc.


Depending on how fast your request is acknowledged by us, you will get the complete project material withing 15-30 minutes. However, on a very good day you can still get it within 5 minutes!

What Clients Say

Our Researchers are happy, see what they are saying. Share your own experience with the world.
Be polite and honest, as we seek to expand our business and reach more people. Thank you.

Project Information

  • CATEGORY : ELECTRICAL AND ELECTRONICS ENGINEERING
  • TYPE : PROJECT MATERIAL
  • FORMAT : MICROSOFT WORD
  • ATTRIBUTE : Documentation Only
  • PAGES : 64 Pages
  • CHAPTERS : 1 - 5
  • PRICE : ₦ 3,000.00

Share Links

Download Post
Download Post

Search for Project Topics

Project topics in Departments

Do you need a writer for your academic work?

Reviews:
A Review on the design and construction of a micro-controller based liquid level detecting system, design, construction, microcontroller project topics, researchcub.info, project topic, list of project topics, research project topics, journals, books, Academic writer.
The project is based on the design and construction of a micro-controller based liquid level detector. This is a system that will measure the level of liquid in a container and display the level on 3 seven segment display screen. The system will output an audio and visual alerting indicator when the tank is full and when the tank is empty. This alarm can be re-set using an override switch... electrical and electronics engineering project topics

THE DESIGN AND CONSTRUCTION OF A MICRO-CONTROLLER BASED LIQUID LEVEL DETECTING SYSTEM